Fibocom L860-GL - CGPIAF, Printing IP Address Format

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 232 of 254
Command Description
+CGEV: ME CLASS B
+CGEV: NW CLASS A
+CGEV: NW MODIFY 20,2,0
+CGEV: NW DETACH
+CGEV: ME PDN ACT 2
OK
11.2.20 +CGPIAF , Printing IP Address Format
This command decides what format to print IPV6 address parameters of other AT commands. See RFC
4291 [88] for details of the IPv6 address format.
The +CGPIAF parameters <IPv6_AddressFormat>, <IPv6_SubnetNotation>, <IPv6_LeadingZeros> and
<IPv6_CompressedZeros> affect the following commands and parameters:
ˆ in +CGTFT and +CGTFTRDP, the <remote address and subnet mask >;
ˆ in +CGDCONT, the <PDP_addr>;
ˆ in +CGPADDR, the <PDP_addr_1> and <PDP_addr_2>;
ˆ in +CGCONTRDP, the <local address and subnet mask>, <DNS_prim_addr>, <DNS_sec_addr>,
<P_CSCF_prim_addr> and <P_CSCF_sec_addr>;
ˆ in +CRC, the <PDP_addr> of unsolicited result code GPRS <PDP_type>, <PDP_addr>[,[<L2P>]
[,<APN>]].
ˆ in +XDNS, the <primary_DNS>, <secondary_DNS> of XDNS Read response.
Command Description
Set [Function]
This command decides what format to print IPV6 address parameters of other AT
commands.
[Syntax]
AT+CGPIAF=[<IPv6_AddressFormat>[,<IPv6_SubnetNotation>[,<IPv6
_LeadingZeros>[,<IPv6_CompressZeros>]]]]
[Response/Action]
OK
or
CME ERROR: <error>