Fibocom L860-GL - Modem Control and Status; 4.1 Modem Register Commands

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 31 of 254
3.1.17 +CLAC, List of All Available AT Commands
This command prints out all AT Commands supported by the Modem.
Command
Description
Execution [Function]
The Execution command displays a list of all the AT commands supported by the
Modem.
[Syntax]
AT+CLAC
[Response/Action]
List of available AT commands
OK
Read N/A
Test N/A
Parameters
N/A
Example AT+CLAC
ATS
ATD
ATA
ATO
...
...
OK
Reference
3GPP TS 27.007
4 Modem Control and Status
4.1 Modem Register Commands
The modem holds certain data items in selected memory space, named Software Registers (S-registers)
and Modem Registers. Some of these registers are used as bitmaps, where one register holds more than
one data item. All S-registers can be accessed using the S command, described in “S, Bit Map Registers”.
Some registers can also be accessed using dedicated commands, detailed below.