Fibocom L860-GL - WS46, Select Wireless Network

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 147 of 254
Command
Description
specifies the System Information messages which give the information about
whether the serving cell supports EGPRS. 3GPP TS 25.331 [74] specifies
the System Information blocks which give the information about whether the
serving cell supports HSDPA or HSUPA.
<reject type> integer type; indicates the type of <reject_cause>.
0 Indicates that <reject_cause> contains an MM cause value, see 3GPP TS 24.008
[8] Annex G.
1 Indicates that <reject_cause> contains a manufacturer specific cause.
<reject cause> integer type; contains the cause of the failed registration. The value
is of type as defined by <cause_type>.
Example AT+CREG=?
+CREG: (0-2)
OK
AT+CREG?
+CREG: 0,1
OK
AT+CREG=2
OK
AT+CREG?
+CREG: 2,1,"A52F","01603413",6
OK
AT+CREG=1
OK
AT+CREG?
+CREG: 1,1
OK
AT+CREG=0
OK
Reference
3GPP TS 27.007
9.1.5 WS46, Select Wireless Network
This command is used to configure the RAT.
Command Description