Fibocom L860-GL - CGPADDR, GPRS Addresses

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 202 of 254
Command
Description
[Response/Action]
+CGACT: <cid>,<state><CR><LF>
+CGACT: <cid>,<state><CR><LF>
+CGACT: <cid>,<state>
OK
Test [Function]
The Test command requests information on the supported PDP context activation
states.
[Syntax]
AT+CGACT=?
[Response/Action]
+CGACT: (list of supported <state>s)
OK
Parameters <state> Indicates the activation state of the context:
0 Non-active
1 Active
<cid> 0-29 A numeric parameter that specifies a particular PDP context definition
Example AT+CGACT=?
+CGACT: (0,1)
OK
AT+CGACT?
OK
AT+CGACT=1
ERROR //GPRS network not present.
Reference 3GPP TS 27.007
11.2.8 +CGPADDR, GPRS Addresses
This command reads the allocated PDP addresses for the specified context identifiers.
Command
Description
Set [Function]
The Set command returns a list of PDP addresses for the specified context identifiers.