Fibocom L860-GL - F, Set to Factory Defined Configuration; Z, Reset to Default Configuration

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 37 of 254
Command Description
OK
4.1.6 &F, Set to Factory Defined Configuration
This command restores the factory default configuration profile. The Modem only supports one factory
default profile, 0.
Command Description
Set [Function]
This is a dummy command in L8 family. It returns OK and has no actual effect.
[Syntax]
AT&F<value>
[Response/Action]
OK
Read N/A
Test N/A
Parameters This is a dummy command and any integer value following &F is accepted.
Example AT&F
OK
4.1.7 Z, Reset to Default Configuration
This command drops the current call, and resets the values to default configuration.
Command Description
Execution [Function]
[Syntax]
ATZ<value>
[Response/Action]
OK
or:
+CME ERROR: <err>
Read N/A