Fibocom L860-GL - CRLP, Radio Link Protocol

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 143 of 254
9.1.3 +CRLP, Radio Link Protocol
This command is used to change the Radio Link Protocol(RLP) parameters used when non-transparent
data calls are originated.
Command Description
Set [Function]
The Set command is used to change the radio link protocol parameters.
[Syntax]
AT+CRLP=[<iws>[,<mws>[,<T1>[,<N2>]]]]
[Response/Action]
OK
or:
+CME ERROR: <err>
Read [Function]
Returns the current CRLP settings
[Syntax]
AT+CRLP?
[Response/Action]
+CRLP= <iws>,<mws>,<T1>,<N2>
OK
Test [Function]
This command returns the list of supported values.
[Syntax]
AT+CRLP=?
[Response/Action]
+CRLP= (list of supported <iws>s),(list of supported <mws>s), (list of supported
<T1>s), (list of supported<N2>s)
OK
Parameters <iws> IWF to MS window size. 0-61.
The default value is 61.
<mws> MS to IWF window size. 0-61.