Fibocom L860-GL - Page 166

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 166 of 254
Command
Description
[Syntax]
AT+CEMODE?
[Response/Action]
+CEMODE : <mode>
OK
Test [Function]
The test command is used for requesting information on the supported MT mode of
operation.
[Syntax]
AT+CEMODE=?
[Response/Action]
+CEMODE: (list of supported <mode>s)
OK
Parameters <mode>:
a numeric parameter which indicates the mode of operation
0 PS mode 2 of operation
1 CS/PS mode 1 of operation
2 CS/PS mode 2 of operation
3 PS mode 1 of operation
Note:
The definition for UE modes of operation can be found in 3GPP TS 24.301 [83]
Other values are reserved and will result in an ERROR response to the set command.
For L830-GL-01:
The default setting of <mode> is 1.
For L810-GL-00,L811-EA-00,L830-EA-00,L830-GL-00,L831-EA-00/01:
The default setting of <mode>is 2.
Example AT+CEMODE=?
+CEMODE: (0-3)
OK
AT+CEMODE?
+CEMODE: 2