Fibocom L860-GL - Page 236

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 236 of 254
Command Description
AT+CGCONTRDP=?
[Response/Action]
+CGCONTRDP: (list of <cid>s associated with active contexts)
Parameters <cid>:
a numeric parameter which specifies a particular non secondary PDP context definition.
The parameter is local to the TE-MT interface and is used in other PDP context-related
commands.
<bearer_id>:
a numeric parameter which identifies the bearer, i.e. the EPS bearer in EPS and the
NSAPI in UMTS/GPRS.
<APN>:
a string parameter which is a logical name that was used to select the GGSN or the
external packet data network.
<source_addr and subnet_mask>:
string type. It shows the IP address and subnet mask of the MT.
The string is given as dot-separated numeric (0-255) parameters on the form:
"a1.a2.a3.a4.m1.m2.m3.m4" for IPv4 or
"a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.m1.m2.m3.m4.m5.m6.m7.
m8.
m9.m10.m11.m12.m13.m14.m15.m16", for IPv6
<gw_addr>:
a string parameter which shows the gateway address of the MT. The string is given as
dot-separated numeric (0-255) parameters.
<DNS_prim_addr>:
A string parameter which shows the IP address of the primary DNS server.
<DNS_sec_addr>:
A string parameter which shows the IP address of the secondary DNS server.
<P_CSCF_prim_addr>:
a string parameter which shows the IP address of the primary P-CSCF server.
<P_CSCF_sec_addr>:
A string parameter which shows the IP address of the secondary P-CSCF server.
<IM_CN_Signalling_Flag>:
A numeric parameter used to show whether the PDP context is for IM CN subsystem-