CAUTION: READ AND FOLLOW ALL SAFETY GUIDELINES AND WARNINGS BEFORE HANDLING OR
ATTEMPTING ANY WORK ON YOUR FIELD ONE PAINTBALL MARKER. SHOULD YOU BE UNSURE AT ANY
POINT, STOP AND GET HELP FROM A FIELD ONE PAINTBALL CERTIFIED TECHNICIAN.
Force Body
The Force Body is the shell that holds the Force together. There are only three o-rings in the force body that seal between both manifolds
and the underside of the body. The Jumper board screws into the mainbody and connects to the main board by way of pressure contact
pads. The Jumper harness connects the jumper board to the Bridge Board which relays information to and from the eyes and power from the
AA batteries in the foregrip to the mainboard. The Force Bridge holds the Bridge Board in place and creates a mounting point for the
gripframe.
A
Rear Gripframe Mounting Screw (insert from inside the body)
A
Leverlock Feedneck
Eye Cover
Mainbody
005 Mainbody to Drive
Manifold
007 Mainbody to Input
Manifold
Jumper Harness
Bridge
Bridge Board (under Bridge)
Battery Harness
Jumper Board
To Next Page
Loading...