38
/
40
6. Connecting with other audio equipment
How to connect the X7’s S/PDIF / coaxial digital output to other equipment?
What to connect it to?
A: First, make sure that the Multifunctional Output (Section F.1.6.c) is set to Coaxial digital out. Then
connect the LINE/COAX OUT port on top of the X7 to the provided S/PDIF adapter cable. (It’s the short
cable with a 3.5mm jack on one end and a single RCA port on the other.) Then connect the other end of the
adapter cable to your equipment’s coaxial S/PDIF input with an appropriate RCA coaxial cable.
Note: Because of the shared pinout of the X7’s line / coaxial output port, it is not compatible with direct 3.5mm
coaxial cables except those specially designed for the X3II / X5II / X7 with an appropriately wired 3.5mm TRRS jack.
See this post for details: http://fiio.me/forum.php?mod=viewthread&tid=40478&page=1&extra=#pid107286
Q: Why does my HT receiver never play the first ten seconds of music from my X7?
A: If the HT receiver is not explicitly set to receive audio from the coaxial port, it takes approximately ten
seconds to detect that audio is not coming in through the HDMI port and switch to the coaxial port. In
this case, please set the HT receiver’s audio input to Coaxial.
7. Other operations
How to get longer battery life for the X7?
A: a) Go to X7’s system settings -> Powertimer -> Idle poweroff to set the Idle poweroff interval; if the
X7 is not playing and does not receive any user input for the set interval, the X7 will power off
automatically to save battery.
Turning down the backlight brightness and turning off the pulsar light can also save battery.
Set the display to sleep after a certain interval of activity (system Settings->Display->Sleep), and lock the
screen before putting the X7 in your pocket, so that the touchscreen does not continue accepting input in
your pocket and keep your X7 active.
Why is the X7 a bit sluggish in responding at times?
To Next Page
Loading...
