Before using this Meter, read the following safety information carefully.
In this manual, the word “WARNING” is used for conditions and actions
that pose hazard(s) to the user; the word “CAUTION” is used for
conditions and actions that may damage this Meter.
International Symbols
Dangerous Voltage ( Risk of electric shock)
Alternating Current (AC)
Direct Current (DC)
Either DC or AC
Ground (Allowable applied voltage range between the input
terminal and earth)
Caution! Refer to the user’s manual before using this
Meter.
Double Insulation (Protection Class ll)
Fuse
This Meter is a handheld and battery operated instrument that is
designed and tested according to IEC Publication 1010-1 (EN 61010-
1) (Overvoltage Category ll), the EMC Directive (EN 50081-1 and EN
50082-1) and other safety standards (see “Specifications”).
Features:
■Accurate measurements of non-filtered (rectified AC) DC signals
■3
1
/
2
digit, 2000 count digital display
■Manual ranging
■Fused 10 Amps range
■DC voltage basic accuracy within 0.5%
■Date hold
■Continuity beeper and diode test
■600 volt input protection on ohm range
■Hold and Low-battery annunciators
■Rubber boot (or Safety holster)
■Large LCD display (68.5mm x 32.7mm)
2 3
1. INTRODUCTION
2. SAFETY CONSIDERATIONS
To Next Page
Loading...
