Page 12
Maintenance
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etch-
ing may cause premature glass failure.
CAUTION!
Fireplace gas control must be in the “OFF” position and pilot
and main burners extinguished when cleaning appliance with
a vacuum.
Doors can get very hot. Handle only when cool.
General
Have the fireplace installation inspected yearly, including a visual
check of the vent system, the burner and the pilot flame. For your
convenience a 1/8" manifold pressure tap is supplied on the gas
valve for a test gauge connection.
For Natural Gas this appliance requires a minimum inlet pressure
of 5.5" W.C. and a manifold pressure of 3.5" W.C.
For Propane this appliance requires a minimum inlet pressure of
11" W.C. and a manifold pressure of 10" W.C.
Always keep the fireplace area clear and free of combustible mate-
rials, as well as gasoline and other flammable vapours and liquids.
Do not use this appliance if any part has been under water. Imme-
diately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been under water.
Cleaning
When the fireplace is first activated, there may be some smoking and
a visible film may be left on the glass. This is a normal condition, and
is the result of burning of protective coatings on new metal.
Glass must be cleaned periodically to remove any film (which is
a normal by-product of combustion) which may be visible. Film
can easily be removed by removing the door, as shown on page
8. Handle the door carefully, and clean it with non-abrasive glass
cleaners. One of the most effective products is Kel Kem.
Silicone seals on inner door during initial firing will "off gas", leav-
ing a visual deposit of a white substance on combustion chamber
walls. This can easily be removed using normal household prod-
ucts.
Use a vacuum cleaner or whisk broom to keep the control com-
partment, burner, and firebox free from dust and lint.
Figure 14. Step 1. (Door
Trim )
Figure 15. Step 2. (removal of
Trim)
Figure 16. Step 3 (Removal of
Door Frame)
Figure 17. (Completed Re-
moval)
Removing and Installing
the Door
Removing the door:
The C-View-PRC Series Door-Window outer trim are held in place by
magnets, and the Door-window frames are held in place by fine-thread
10-24 screws. Follow the process below to remove, or install the items
described.
Figure 14. The Fireplace as it is received from Montigo.
Figure 15. (Step 2) Remove the Door-window trim by grasping the metal
firmly and pull it free it from the frame. Note: Hold it as shown in Step 2
to release the hold of the magnets.
Figure 16. (Step 3) Remove the Door-window assembly by turning the
10-24 screws counterclockwise. Note: Have someone hold the door-
window assembly in place until all screws are removed. Then grab the
assembly from either end lifting it away from the fireplace. Place it in a
safe location to store or clean.
Figure 17. (Step 4) Removal is complete. Proceed with service or
cleaning.
To Next Page
Loading...
Need help?
General