Fire Sense Pro Series

To Next Page

DANGER

FOR YOUR SAFETY: If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. If odor continues, keep away from the

appliance and immediately call your gas

supplier or fire department.

DANGER

DANGER indicates an imminently hazardous

situation which, if not avoided, will result in

death or serious injury.

DANGER

Failure to comply with the precautions and

instructions provided with this heater can

result in death, serious bodily injury and

property loss or damage from hazards of fire,

explosion, burn, asphyxiation, and/or carbon

monoxide poisoning. Only persons who can

understand and follow the instructions should

use or service this heater.

WARNING

Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any

other appliance. An LP cylinder not connected for

use shall not be stored in the vicinity of this or

any other appliance.

WARNING

Improper installation, adjustment, alteration,

service or maintenance can cause property

damage, injury or death. Read the installation,

operation and maintenance instructions

thoroughly before installing or servicing this

equipment.

WARNING

FOR OUTDOOR USE ONLY!

Comfort, Quality & Style Since 1998

Pro Series Patio Heater

Item#:

61159, 61436

ATTACH YOUR RECEIPT

Keep a copy of your proof of purchase

or order confirmation which will be

required if you need to contact us

about warranty coverage.

Serial No.

Purchase Date

WARNING

This product can expose you to chemicals

including Carbon Monoxide, Lead, Chromium

(hexavalent compounds), Di(2-ethylhexyl)

phthalate (DEHP) and Diisononyl phthalate

(DINP), which are known to the State of

California to cause cancer and birth defects or

other reproductive harm. For more information,

go to www.P65Warnings.ca.gov.

ATTENTION

If your patio heater model is equipped with a

base

weight/sand box, it is strongly recommended

that

you fill it with sand or fine gravel and attach it

securely to the bottom of the heater. In windy

conditions, store the heater in a protected area or

otherwise secure it. Unsecured heaters can be

blown over in moderate to high wind. Damage

due to weather or acts of God is not covered

under warranty.

Questions, problems, missing parts?

Before returning to your retailer, our Florida-based customer service team is available:

Call toll-free

(866) 985-7877

9 a.m. – 9 p.m., EST

Live chat

cservice@welltraveled.net

www.balkenehome.com 9 a.m. – 6 p.m., EST, Monday - Friday

04202021

Main Page

Need help?

Do you have a question about the Fire Sense Pro Series and is the answer not in the manual?

Summary

Safety Warnings and Precautions

Hazard Alerts and Safety Instructions

Critical safety warnings including DANGER, WARNING, and ATTENTION notices for safe operation.

Detailed Safety Information

Fire and Explosion Hazards

Details on preventing fire and explosion hazards related to combustibles and propane.

Carbon Monoxide and Air Quality Hazards

Information on carbon monoxide risks and the need for ventilation.

Burn Hazards and General Warnings

Assembly Instructions

Assembly Preparation and Step 1

Prepares for assembly and details attaching wheel brackets to the base.

Assembly Step 2: Post Supports

Instructions for attaching post supports to the base.

Continued Assembly Instructions

Assembly Step 3: Attaching the Post

Guides on securing the post to the base using bolts and nuts.

Assembly Step 4 & 5: Housing and Head Assembly

Covers sliding the tank housing and attaching the head assembly.

Assembly Step 6: Reflector Assembly (Model 61436)

Pre-Operation Checks and Setup

Performing Leak Tests

Step-by-step guide to check for gas leaks using a soapy water solution.

Pre-Gas Supply and Lighting Checks

Heater Operation and Lighting

Lighting Procedure and Ignition

Detailed steps for safely lighting the patio heater using the electronic ignition.

Heater During Operation and Shut Down

Troubleshooting Common Issues

Burner Not Lighting or Low Flame

Solutions for issues where the main burner fails to light or has a low flame.

This document describes the Fire Sense Pro Series Patio Heater, models 61159 and 61436, providing comprehensive information on its function, technical specifications, usage, and maintenance.

Function Description:

The Fire Sense Pro Series Patio Heater is a combustion appliance designed for outdoor heating. It operates using propane gas, providing radiant heat to an outdoor area. The heater is intended for use with a propane vapor withdrawal supply system and is designed to produce extremely minute, non-hazardous amounts of carbon monoxide (CO) when used and maintained according to instructions. It features an electronic ignition system, requiring one AAA battery for operation. The heater is equipped with a reflector to direct heat, a head assembly containing the burner, a tank housing for the propane cylinder, a post, and a base, which may include a pre-installed sandbox for stability. Some models (e.g., 61436) feature a multi-panel reflector for easier assembly and potentially broader heat distribution.

Important Technical Specifications:

Fuel Type: Propane gas.
Propane Cylinder: Standard 20 lb. propane cylinder (sold separately), equipped with a listed over-filling prevention device and a collar to protect the cylinder valve.
Minimum Supply Pressure: 0.5 psi for input adjustment of propane gas.
Ignition: Electronic ignition, requires 1 AAA battery (installed by unscrewing the RED IGNITER BUTTON).
Reflector: Model 61159 has a 1-piece reflector; Model 61436 has a 5-piece reflector (4 panels and 1 center cap).
Clearances from Combustible Materials: Minimum 3 feet (36 inches) from the top and 2 feet (24 inches) from the sides.
Operating Temperature: Unit will operate at reduced efficiency below 40°F.
Assembly Time: Approximately 60 minutes.
Tools Required (NOT included): Phillips screwdriver w/medium blade, adjustable wrench (2), leak test solution.
Materials: Stainless steel models benefit from high-quality automobile wax for exterior surface maintenance (excluding emitter screen or domes).

Usage Features:

Outdoor Use Only: The heater is strictly for outdoor use and must not be operated inside a building, garage, or any other enclosed area due to carbon monoxide hazard and oxygen consumption.
Gas Connection: Connects to a standard 20 lb. propane cylinder via a regulator and gas hose. Connections must be hand-tightened and then securely tightened with a wrench.
Leak Testing: A crucial step before initial use and after any gas connection is loosened or removed. A solution of soapy water is applied to connections; bubbles indicate a leak. Leak tests must be performed outdoors, away from open flames and smoking.
Lighting Procedure:
1. Turn the control knob to "OFF" (9 o'clock position).
2. Fully open the LP cylinder valve.
3. For initial start or after cylinder change, hold the control knob in for 2 minutes to purge air.
4. Turn the control knob to align the calibration mark halfway between the small and large flame symbols.
5. Depress the control knob, then push the RED igniter button to ignite the main burner. Hold until burner ignites (approx. 30 seconds), then release.
Flame Adjustment: Turn the control knob clockwise for a larger flame, counter-clockwise for a smaller flame.
Shut Down: Depress the control knob and turn clockwise to "OFF." Turn the cylinder valve clockwise to "OFF" and disconnect the regulator when not in use.
Safety Precautions:
- Never leave the heater unattended when hot or in use.
- Keep children and flammable materials away from hot surfaces.
- Do not hang clothing or other flammable materials on or near the heater.
- Ensure adequate clearances from combustibles.
- Do not store propane near high heat, open flames, or where temperatures exceed 120°F (49°C).
- Propane cylinders should be stored outdoors in a well-ventilated space, out of reach of children, and never in an enclosed area.
- Do not attempt to manually ignite the heater by holding the control knob for more than 10 seconds before igniting, as this can cause a ball of flame.
- Heater will be hot after use; handle with care.

Maintenance Features:

Regular Inspection: The heater should be thoroughly inspected before each use and annually by a qualified service person.
Cleaning Exterior Surfaces: Use soapy water; avoid flammable or corrosive cleaning agents. Keep the burner and control compartment dry.
Airflow Maintenance: Ensure controls, burner, and circulating air passageways are clean and unobstructed. Signs of blockage include gas odor with extreme yellow flame, heater not reaching desired temperature, uneven glow, or popping noise.
Burner Cleaning: Spiders and insects can nest in burner orifices. Clean burner holes with a heavy-duty pipe cleaner or compressed air.
Carbon Deposits: Clean dome and burner screen with warm soapy water if carbon deposits develop.
Hose Assembly Inspection: Inspect for excessive abrasion, cuts, or wear. Replace if leaks are suspected.
Corrosion: In salt-air environments, check frequently for corroded areas and repair promptly.
Storage:
- Between uses: Turn control knob OFF, disconnect LP source.
- Store upright in an area sheltered from inclement weather.
- Cover the heater to protect exterior surfaces and air passages.
- Do not leave the LPG tank exposed to direct sunlight or excessive heat.
- Wait until the heater is cool before covering.
Service: Only a qualified service person should repair gas passages and associated components. Always allow the heater to cool before attempting service.
Warranty: The Fire Sense Pro or Lux Series Heater comes with a 1-year warranty on materials and workmanship under normal use, and a limited lifetime warranty on the head/burner unit for defects in material and workmanship under normal use. Warranty extension for an additional year is available upon product review at balkenehome.com within 365 days of purchase.