How to deactivate the smoke alarm:
Press test button and hold it for about 10 seconds until LED
ashes rapidly (ash 5 times per second), then press Test
button rapidly at least 6 times within 5 seconds (or while LED
ashes rapidly). The unit will generate a “beep” indicating the
product is in inactivation mode. There will be no functions in
this state. You must reactive it before use. Please refer to the
chapter “installation” for activating the product
Note: Deactivate this alarm if you need to disposal it or stop
nuisance alarm which is caused by a failure of their function.
Practice Fire Safety:
If the alarm sounds, and you have not pushed the test button,
it is warning of a dangerous situation, your immediate
response is necessary. To prepare for such occurrences,
develop family escape plans, discuss them with all household
members, and practice them regularly.
1: Expose everyone to the sound of a smoke alarm device and
explain what the sound means.
2: Determine two exits from each room and an escape route to
the outside from each exit.
3: Teach all household members to touch the door and use
an alternate exit when the door is hot, instruct them not to
open the door if the door is hot.
4: Teach household members to crawl along the oor to stay
below dangerous smoke, fumes and gases.
5: Determine a safe meeting place for all members outside the
building.
What to Do in Case of Fire:
1: Do not be panic; stay calm.
2: Leave the building as quickly as possible. Touch doors to
feel if they are hot before opening them. Use an alternate
exit if necessary. Crawl along the oor, and do not stop to
collect anything.
3: Meet at a pre-arranged meeting place outside the building.
4: Call the re department from outside the building.
5: Do not go back inside a burning building. Wait for the re
department to arrive.
Note: These guidelines will assist you in the event of a re,
however to reduce the chance that res will start, practice re
safety rules and prevent hazardous situations.
Warranty Information:
Company warrants to the original consumer that each new
smoke alarm device to be free from defects in material and
workmanship under normal use and service for a period of 10
years from the date of purchase. This warranty does not cover
damage resulting from accident, misuse or abuse or lack of
reasonable care of the product.
In no case shall company be liable for any incidental or
consequential damages for breach of this or any other
warranty express or implied, whatsoever. The defective
product can be mailed to the address on page 6 with details
explaining the problem.
Where is the best place to install alarm:
• Install the rst alarm in the immediate area of the bedrooms.
Install additional alarms to monitor the exit path, as the
bedrooms are usually farthest from the exit. If more than
one sleeping area exists, locate additional alarms in each
sleeping area (see Diagram 3).
• Install additional alarms to monitor any stairway as
stairways act like chimneys for smoke and heat.
• Install at least one alarm on every oor level ( see Diagram
4)
• Install an alarm in every bedroom.
• Install an alarm in every room where large electrical
appliances are operated (for example portable heaters ).
• Install an alarm in every room where someone sleeps with
the door closed. The closed door may prevent an alarm
located outside from waking the sleeper.
• Smoke, heat, and combustion products rise to the ceiling
and spread horizontally. Mounting the smoke alarm on
the ceiling in the centre of the room places it closest to all
points in the room. Ceiling mounting is preferred in ordinary
residential construction.
• When mounting an alarm on the ceiling, locate it at a
TOTAL HOME PROTECTION
Diagram 2
- 4 -
To Next Page
Loading...
