Why does my Firman P03612 engine hunt or falter?
If your Firman Portable Generator engine “hunts” or falters, it might be due to a clogged or dirty fuel filter. In this case, clean or replace the fuel filter.
What to do if Firman P03612 engine will not start?
If your Firman Portable Generator engine won't start, starts and runs rough, or shuts down while running, here are several things to check: * Ensure the engine switch is in the ON (l) position. * Make sure the fuel shutoff lever is in the ON (l) position. * Check and fill the oil to the proper level, ensuring the generator is on a level surface. * Inspect and clean or replace the air cleaner if it's dirty. * Verify that there is enough fuel in the tank and that the fuel is fresh (drain and refill if stale). * Confirm the spark plug wire is connected to the spark plug, and replace the spark plug if it's bad. * Drain the fuel tank and carburetor and refill with fresh fuel if there's water in the fuel. * If the engine is flooded, wait 5 minutes before re-cranking. * Clean o...
What to do if my Firman P03612 engine will not start?
If your Firman Portable Generator engine won't start, consider these potential causes: * The engine switch may be in the OFF (O) position; set it to the ON (l) position. * The fuel shutoff lever may be in the OFF (O) position; move it to the ON (l) position. * The oil level might be low; fill the crankcase to the proper level or place the generator on a level surface. * The air cleaner could be dirty; clean or replace it. * The fuel tank may be empty; fill it with fuel. * The fuel may be stale; drain the fuel tank and carburetor and fill with fresh fuel. * The spark plug wire may not be connected; connect it to the spark plug. * The spark plug may be bad; replace it. * There might be water in the fuel; drain the gas tank and carburetor and fill with fresh fuel. * The e...
What to do if Firman P03612 remote start system is not working?
If the remote start system on your Firman Portable Generator isn't working, try the following: * Replace the batteries in the remote control. * Move closer to the generator, ensuring you are no more than 164 feet away. * Program the remote control to the generator (refer to the section 'Programming the Generator for Remote Start').
Why does my Firman P03612 engine “hunt” or falter?
If your Firman Portable Generator engine "hunts" or falters, a potential cause is a clogged or dirty fuel filter. Clean or replace the fuel filter.
What to do if Firman P03612 Portable Generator engine is running, but no AC output is available?
If your Firman Portable Generator engine is running but there's no AC output, check these items: * The circuit breaker might be open. Reset the circuit breaker. * There may be a poor connection or defective cord set. Check and repair as needed. * The connected device might be faulty. Connect another device that is in good condition.
What to do if Firman P03612 engine lacks power?
If your Firman Portable Generator engine lacks power, consider the following: * The load might be too high. Consult the manual section about not overloading the generator. * The air filter might be dirty. Replace the air filter. * The fuel filter might be clogged or dirty. Clean or replace the fuel filter. * The spark arrester might be clogged. Clean or replace the spark arrester.
Why does my Firman P03612 engine run good at no-load but bogs down when loads are connected?
If your Firman Portable Generator runs well without a load but bogs down when you connect devices, it could be due to several reasons: * A short circuit in the connected load. Try disconnecting the electrical load. * The generator is overloaded. See the manual section about not overloading the generator. * A clogged or dirty fuel filter. Clean or replace the fuel filter.
Why is the remote start system not working on my Firman P03612?
If the remote start system on your Firman Portable Generator isn't working, check these: * The remote control may have low batteries; replace them. * You might be exceeding the remote control's range; move closer to the generator (must be no more than 164 feet).
How to fix a Firman P03612 that will not start or runs rough?
If your Firman Portable Generator engine will not start, starts and runs rough, or shuts down, make sure the engine switch is in the ON position and the fuel shutoff lever is also in the ON position. Check the oil level and add oil if it's low, or place the generator on a level surface. Inspect the air cleaner and replace it if it's dirty. Ensure there is fuel in the tank, and if the fuel is stale, drain and replace it with fresh fuel. Verify the spark plug wire is connected, and replace the spark plug if it's bad. If the engine is flooded, wait 5 minutes before re-cranking. If equipped with a starting battery, ensure it has sufficient charge.
General| Fuel Type | Gasoline |
|---|---|
| Engine Displacement | 208 cc |
| Starting System | Recoil Start |
| AC Output | 120V |
| Generator Type | Inverter Generator |
| Engine Type | 4-Stroke |
| Noise Level | 58 dBA |
| Outlets | 2 x 120V 20A (5-20R) Duplex, 1 x 12V DC |
| DC Output | 12V, 8.3A |
| Starting Watts | 3600 Watts |
To Next Page
