Ð10Ð
SECURITY CODES
General At the time of installation, your installer programmed a personal four-digit
Master code, known only to you and yours. This code is used to perform
most system functions, including arming and disarming of the system. As an
additional safety feature, temporary user codes can be assigned (see next
page) for use by those not having a need to know the Master code. Note
that the Master code remains in effect even when other user codes are
assigned.
Duress Code
Ask your installer if
"Duress" is active for
your system, and if so,
check here: Ê Ê Ê
This feature is intended for use when you are forced to disarm or arm the
system under threat. When used, the system will act normally, but can
silently notify the central station of your situation, if that service has been
provided.
The Duress code is defined as user number 8.
Important: The Duress code is useful only when connected to a central
station.
Quick Arming
Ask your installer if
"Quick Arming" is active
for your system, and if
so, check here: Ê Ê Ê
If your system supports "Quick Arming", the "#" key can be pressed in
place of the security code when arming the system. The security code is
always
required, however, when disarming the system.
To Next Page
Loading...
Need help?
General
