Ð11Ð
SECURITY CODES
To Assign, Change,
or Delete
User Codes
4-DIGIT USER CODES
It is recommended that
obvious codes such as
1111 or 1234 not be
assigned.
Important:
Temporary users should not
be shown how to use any
system function they do not
need to know (e.g., bypassing
protection zones).
1. Enter your Master code and press the CODE key.
2. Enter single-digit User Number (2Ð7) for which a code is to be
assigned, changed, or deleted.
3.
If
assigning or changing a user's code,
enter the desired
4-digit code for use by that User Number. The keypad will beep once.
If deleting a user's code,
perform steps 1 & 2 and stop. In a few
moments the keypad will beep once, indicating that the existing code
has been deleted.
To assign your Duress code, do the following:
Enter your [Master code] + [8] + [8] + [desired 4-digit code]. The keypad
will beep once.
The Master code can be changed by the main user of the system. To
change it, do the following:
Enter your [Master code] + [8] + [1] + [new Master code] + [new
Master code] again. The keypad will beep once.
A
B
C
D
OFF AWAY
STAY
MAXIMUM
TEST
BYPASS
INSTANT
CODE
CHIME
READY
1
2
3
4
5
6
7
8
9
*
0
#
{
THESE KEYS
NOT PRESENT
ON ALL
KEYPADS
USE THE CODE
KEY TO ASSIGN
OTHER USER
CODES
“QUICK ARM” KEY
(IF PROGRAMMED
)
TYPICAL KEYPAD
To Next Page
Loading...
Need help?
General
