EasyManua.ls Logo

First Alert FA2000C - Section 8; System Operation; User Codes

First Alert FA2000C
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-1
SECTION 8
System Operation
•••••••••••••••••••••••••••••••••••••••••••••••••
User Codes
This system provides 1 Installer Code and 5 Secondary Codes (Users 2-6). These are described below.
User codes are required only if a keypad is installed on the control.
Installer Code
The installer programs the 4-digit Installer Code initially as part of the programming procedure. The Installer Code is
the only code that can allow re-entry into programming mode and also, in normal operation mode, is used to enter the 4-
digit code for the main user (user #2), which allows access to the normal functions of the system (The main user {#2} may
also enter additional users, 3-6).
Adding, Changing, and Deleting Secondary User Codes
In normal operation mode, the Installer Code (and user code #2) may be used to assign up to 5 additional
4-digit user codes. It can also be used to remove Secondary Codes from the system (individually).
To assign (or change) a Secondary user code, enter (via keypad):
Installer Code + [CODE key] + User # (2–6) + desired Secondary Code (4-digits)
The system will emit a single beep when each Secondary Code has been successfully entered.
To delete a Secondary user code, enter (via keypad):
Installer Code + [CODE key] + User # (2–6)
NOTES:
All Installer and Secondary user codes permit access to the system for silencing and resetting alarms.
The Installer Code may assign user codes 2-6.
User 2 may assign user codes 3-6.
The Installer Code may bypass ALL zones while users 2-6 may bypass 24 hour non-fire zones only.
The Installer Code may initiate both the Walk Test and Fire Drill Test.
User 2 may initiate the Fire Drill Test only.
Users 3-6 may NOT initiate any of the test modes.
If a Secondary Code is inadvertently repeated for different users, the lower user number will take priority.
User Code Function Summary Table
User # Enter Program
Mode
Silence Alm,
Trbl, Supv
Add/Change
Users
Bypass
Zones
Enter Test
Modes
1 Installer
Yes Yes 1-6 All All
2 Main User
No Yes 2-6 24 hour only Fire Drill only
3-6
No Yes No 24 hour only None

Table of Contents

Other manuals for First Alert FA2000C

Related product manuals