First Data FD200Ti - Lets get started...; Where to put the FD Terminal; Loading the paper; Installing the ink

Let’s get started…
Typical set-up time: 5–10 minutes
Where to put the FD Terminal
Placetheterminalonadeskortabletop.Avoidareaswith
directsunlight,objectsthatradiateheat,excessivedustand
otherelectricaldevicesthatcancauseexcessivevoltage.
Loading the paper
Poptheprintercover’slatchtoopenthecover;thenliftthe
cover.Loadarollofpaper(AppletonPOSGradePlus600-2.4
isrecommended)intotheprinter.Thethermalprint-sideof
thepaperwillfeedoutfacingtheoperator.Closethecover
andtearoffanyexcesspaper.
Installing the ink
Gentlypresstheinktraylatchatthesideofcheckreaderof
FD200
Ti
,andthentheinktraycoverpopsopen.Pushtheblackink
tray,andthenfliptheinktrayleftgently.Putthenewinkcartridge
intothetrayandlifttheleveruptofastentheinkcartridge.
Get connected
YoumaychooseanIPconnection(DSLorcable)ordial-up.Ifyou
choosedial-upyoucanuseadedicatedphoneline,thesameline
asyourfaxmachineoranyotherjacknotpluggedintoaphone
systemorLAN(LocalAreaNetwork).
6