Firstcom FC-136 - Select Scan Modes

1. Press [ ], and rotate simultaneously the power knob to turn ON the transceiver.
2. Press [ ] / [ ] key to select the SETRST menu, then press [ ] key twice to finish the setting.
All Reset
To initialize all setting.
1. Press [ ] key, and rotate simultaneously the power knob to turn on the transceiver.
2. Then press [ ] key twice to finish the setting.
33
Select Scan Modes
1. Press [ ], [ ] to enter menus.
2. Select the menu 18 (SCN MD). 
3. Press [ ] key to enter the menu, press [ ] / [ ] keys to select the scan type (TO/CO/SE).
4. Press [ ] key to finish setting.
5. Press [ ] to exit the menu setting.
VFO Scan
VFO Scan scans all the frequencies with band.
1. Under the VFO mode, press [ ], [ ] keys to begin scanning.
Scan begins from the current frequency.
To invert the scan direction, press [ ] key (frequency increase) or press [ ] (frequency decrease) .
34
2. To cancel VFO scan, press any key except [ LAMP ], [ MONI ] and [ ] / [ ].
Note: The squelch function must be OFF before scan.
Memory Channels Scan
Memory Channels Scan scans all the stored memory channels.
1. Press [ ] key to enter the memory channels.
2. Press [ ], [ ] keys to scan.
Scan from the current channel
To invert the scan direction, press [ ] key (frequency increase) or press [ ] (frequency decrease) .
3. To cancel the memory channel scan, press any key except [ LAMP ], [ MONI ] and [ ] / [ ].
Note: At least two memory channels required.
The squelch function must be closed before scan.
Skip Memory Channels
You can lock the memory channel you don’t want to scan.
1. Select a memory channel to set as a skip channel.
2. Press [ ], [ ] keys to set the skip channel.
Note: PRI is invisible on LCD on skip channels