Firstech AQUABED User Manual

If the AquaBed Water Heater is on, the unit will automatically pump the water into
the Mattress Pad. The three water level bars indicate the amount of water in the
AquaBed Water Heater.
As the AquaBed Water Heater pumps water into the Mattress Pad, the LEDs may
indicate a shortage of water.
Pour water into the AquaBed Water Heater until the water level indicator reads
“full”. If you see an “E1” message on the LCD, please pour more water into the
AquaBed Water Heater.
Upon initial installation, the AquaBed Water Heater may generate slight
noises/vibrations. The unit is removing all of the air pockets inside of the system
and will only last up to 90 seconds.
The temperature displayed on the bottom right side of the LCD indicates the
current water temperature within your system.
You can easily set your desired temperature by using UP and DOWN buttons. The
temperature range is 50°F to 158°F(10°C to 70°C).
www.aquabedwarmer.com
7
8
9
10
11

Firstech AQUABED Specifications

General

Brand	Firstech
Model	AQUABED
Category	Water Heater
Language	English