https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
10
STEP 2: Turn ignition to the ‘ON’ position and leave driver’s door open. (Door Input must be
connected)
STEP 3: Hold your finger over the ‘Red Circle’ icon for 3 seconds.
STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the
number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will get 1
siren chirp and LEDs will flash in a circular pattern.
STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.
Alarm Arm/Lock
To rearm hold your finger on the ‘Red Circle’ for 3 seconds.
Alarm Disarm/Unlock
To disarm hold your finger over the ‘Red Circle’ for 3 seconds. Once the LEDs start their circular pattern,
enter your 4-digit code by touching the window with the flat part of the tip of any finger over the number for
each digit of your code. (Refer to Step 4 above or training video at https://www.youtube.com/c/myFirstech)
Two seconds after entering the 4th digit, your system will first re-arm/lock. In two seconds, it will disarm/
unlock.
2 Way LCD remote paging
To page a 2 Way LCD remote, hold your finger over the ‘Red Circle’ twice.
Touch Panel Sensitivity
To change touch sensitivity, open the driver’s door, hold the button on the back of the RPS Touch until the
LEDs go out. Release button and tap again. The number of solid LEDs represent sensitivity of touch, 1
being the lowest, 5 the highest.
RPS Touch on or Off
You can turn the RPS Touch off from your remote. Just follow the instructions below:
STEP 1: Enter remote programming mode by holding down buttons 2+3 (Trunk and Key/Start buttons
on 2W901R-SS) simultaneously for 2.5 seconds. The remote will beep once and the LCD or
read “REMOTE MENU” indicating that you have entered programming mode.
STEP 2: Scroll through the remote options by tapping button 3 or 4 (Function button 2W901R-SS).
Once the LCD RPS icon flashes reads “RPS-ON” tap button 1 or (Lock button 2W901R-SS)
to turn this feature on. The LCD will read “RPS-OFF”
STEP 3: Exit remote programming by holding down buttons 2+3 (Trunk and Key/Start 2W901R-SS)
buttons simultaneously for 2.5 seconds. The remote will beep indicating that you have
successfully exited programming.
To Next Page
Loading...