https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
11
2. KP2 Keyless Entry window sensor: Unlock/Disarm (KP2 option must be selected on feature 3-16)
Arm/Lock functions do not require programming, however, to unlock/disarm your vehicle you must program
a 4, 5 or 6 digit PIN (numbers 1 through 6 only) using the instructions below(you can view our video library
for programming instructions at: https://www.youtube.com/c/myFirstech):
STEP 1: Disarm/unlock the alarm (remote must be programmed first) and choose a 4 – 6 digit PIN.
You cannot have zeros.
STEP 2: Turn ignition to the ‘ON’ position and leave driver’s door open. (Door Input must be connected)
STEP 3: Hold your finger over the “Lock” icon for 3 seconds.
STEP 4: When the siren chirps and LED flash, momentarily place your finger over the first number of
your 4-6 digit code. The siren should chirp quickly indicating the number has been accepted.
STEP 5: Repeat Step 4 until all four to six digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your KP2 is now programmed.
Alarm Arm/Lock
Hold your finger over the Lock Icon for 2.5 seconds to lock/arm the system.
Alarm Disarm/Unlock
To disarm, enter the 4-6 digit code by placing your finger over the correct digits in sequence. If entered
correctly the system will disarm, if the code entered is incorrect the LED’s will flash 3 times (the siren will
chirp 3 times if installed) and an alert will be sent to any Firstech 2way LCD remote or Drone that may be
connected to the CM. NOTE: If you enter the wrong code more than 5 times within 30 minutes the KP2
disarm function will be disabled for 1 HOUR or until ignition has been cycled.
To Next Page
Loading...