Firstech CM-X - Page 12

CMX is t
he
Solution
https:// install.myfirstech.com
CMX
Master
Guide
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
12
FT-DASII (Digital Adjustable Sensor gen II) (Included with FT-ALARM IT upgrade kits, or sold separately)
The DAS II has a built-in accelerometer that monitors sudden movement forward or backward during the remote
start process when starting a manual transmission vehicle. DAS II ACCCELERAMETOR DOES NOT WORK IN
AUTOMATIC TRANSMISSION MODE. Warning: DO NOT CUT THE LOOP FOR MANUAL
TRANSMISSION VEHICLE Manufacturer or seller assumes no responsibility for any injuries and/or
damages caused by this improper conversion and transform of the product done by a user voluntarily.
The DAS II also includes a dual stage impact sensor, and auto adjusting tilt sensor, and glass break sensor all in
one. Follow the steps below to properly setup your DAS II sensor levels. You can view our programming/
demonstration video located in our video library at https://www.youtube.com/c/myFirstech
DAS-II Programming Procedure
STEP 1: Turn the ignition to the ‘on’ position
STEP 2: Send Unlock command 2 times (unlock => unlock) using any Firstech remote, Drone, or
OEM remote with “OEM remote control” supported over data. At this time the DAS-II
display will initialize and stay powered up for at least 5 minutes or until ignition is off.
STEP 3: Push the programming button repeatedly until the desired sensor has been selected 1-5
shown in the table below. (The programming button will be used to navigate the sensor
adjustments and sensitivity once a sensor has been selected.)
STEP 4: Once the sensor has been selected hold the programming button for 2 seconds to
confirm selection and enter sensitivity adjustment. The adjustment options will
now be accessible with default setting displayed. (sensitivity options will be
shown in table below.)
STEP 5: push the programming button repeatedly until desired sensitivity level is reached
(setting 0 will indicate sensor is OFF => except option 2 window break
sensor conditions)
STEP 6: Hold programming button for 2 seconds to save sensitivity setting. After the
setting is saved the sensor will start over at sensor 1 again. (if the programming
button is not pressed within 5 seconds after setting the LED will flash 2 times
save the setting and exit that sensor programming)
STEP 7: Turn ignition off to exit programming