Firstech CM-X - Page 14

To Next Page

To Previous Page

CMX is t

Solution

https://

install.myfirstech.com

CMX

Master

Guide

CMX will support 2 alternative Shock sensor level adjustment procedures.

Adjusting DASII Shock Sensitivity alternative procedure option 1

STEP 1: Turn the ignition to the ‘on’ position.

STEP 2: 2 Way remotes-hold buttons 1 and 2 (Lock and Unlock) for 2.5 seconds. You will get two

parking light flashes. 1 Way remotes-hold Lock and Unlock for 2.5 seconds. You will get two parking

light flashes.

STEP 3: To set the Warn Away Zone 1, (2way LCD) tap lock or button I. (1 Way) tap Lock. After you

get one parking light flash, proceed with impact testing on the vehicle. Note: please be careful as not to

damage the vehicle during the sensitivity adjustments. You will get siren chirps 1-most sensitive

(lightest impact to the vehicle requiring the least amount of force to trigger warn away) through 10-

least sensitive (heaviest impact to the vehicle requiring more force to trigger warn away). This sets

the impact sensitivity of Warn Away Zone 1. Setting Zone 1 will automatically set Zone 2. If you

would like to manually set Zone 2 proceed:

To set Instant Trigger Zone 2

a. Repeat Steps 1 and 2

b. Tap the Unlock button on your Firstech remote, the parking lights will flash 2 times.

c. After you get two parking light flashes, tap the vehicle. You will get siren chirps 1-most

sensitive through 10-least sensitive. This sets the impact sensitivity of Instant Trigger Zone 2.

STEP 4: Once you get two parking light flashes, you are ready to test your DASII.

Adjusting DASII Shock Sensitivity alternative procedure option 2

STEP 1: Turn the ignition to the ‘on’ position

STEP 2: Hold Foot Brake (make sure the CM sees a valid foot brake input)

STEP 3: Tap Lock 3 times from any Firstech remote (including 1Button remotes)

STEP 4: Release Foot Brake *Parking lights will flash 2 times confirming DAS is in programming mode

STEP 5: The CM will chirp/honk/flash (1-10 times) indicating the current sensitivity level

STEP 6: Using any Firstech remote, OEM remote (capable of Controlling the CMX through data

module), or the Arm/Disarm analog inputs, tap lock, or unlock 1 time to increase or decrease 1

level of sensitivity (up to 10 (least sensitive) or down to 1 (most sensitive)) which should be

confirmed by chirps/horn honks/ flashes

*repeat this process until desired sensitivity level has been reached