Firstech CM-X - Page 15

To Next Page

To Previous Page

CMX is t

Solution

https://

install.myfirstech.com

CMX

Master

Guide

a. Example 1. Current sensitivity level is 4, we send 1 lock command after 1 second of no

incoming commands we should receive 1 chirp or 1 horn honk indicating we have

moved up 1 level.

b. Example 2. Current level is set at 4, we send lock + lock + lock, after 1 second of no

incoming commands we should receive 3 chirps or horn honks honk indicating we have

moved up 3 levels.

c. Example 3. Current level is now set at 7, we send unlock + unlock, after 1 second of

no incoming commands we should receive 2 chirps/horn honks/park light flashes

indicating we have moved down 2 levels.

STEP 7: 5 seconds after the last setting change confirmation the CM will chirp/horn honk/flash the

sensitivity level *you will have an additional 5 seconds to make any adjustments

STEP 8: Programming completed.

STEP 9: You are now ready to test the DASII.

FT-RFID (sold separately as an RF-kit)

The FT-RFID function, now included with 2 of the latest 2-way remotes from Firstech, will unlock/disarm the

vehicle when in range of the antenna (ANT-2WSF).

Install prep for FT-RFID

STEP 1: Set Option 1-14 to Setting 1 or 2 (option 4 is no longer available please see passive arming

feature 1-08 for additional options)

STEP 2: Connect ANT-2WSF using supplied 4 pin to 6 pin antenna cable.

STEP 3: ANT-2WSF mounting requirements will vary with the vehicle type. The proximity unlocking

range is approximately 3-6 ft from the antenna based on its mounting location. The proximity

feature will perform much better out of direct sunlight and above freezing temperatures so

consider mounting the ANT-2WSHF behind an “A” or “B” pillar or under the dash.

Testing The FT-RFID

STEP 1: Make sure your FT remotes are programmed

STEP 2: Enable the proximity unlock feature on one of your FT remote using the remote menu. NOTE:

once the feature is enabled for 1 remote it is enabled for both remotes

STEP 3: Proximity unlock/disarm - Once the CM has been locked/armed allow 15 seconds for the RFID

remote to unlock/disarm the system once its within proximity (approximately 3ft-7ft) of the

ANT-2WSF antenna. i.e. Arm the system wait 15 seconds walk up to the vehicle and it will

automatically unlock/disarm.