Firstech CM-X - Page 28

CMX is t
he
Solution
https:// install.myfirstech.com
CMX
Master
Guide
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
28
Connector 10 (CN10), 6-Pin Lock Accessory port
Note: This harness is NOT included with CMX wire harness kits. The Lock (POC
3), Unlock (POC 4), Trunk (POC 7) release outputs have been moved to CN5 (Grey 20 pin accessory
harness) and are programmable outputs. This connector will still be available for any Firstech lock
harness. (FT-DM600 or FT-DM700)
Pin 1 None - 12v B+ constant output: available when using a Firstech door lock Module DM600, DM700
Pin 2 Violet/White - Trunk release 250mA, 800mS negative (-) output: This is an optional output that will
release the trunk. Use CN1, Pin 2 if the vehicle is equipped with a (+) trunk release. System will unlock
doors and disarm alarm prior to trunk release.
Pin 3 Orange/Black - 2nd Unlock 250mA, 800mS negative (-) output: This is an optional output that will
provide a (-) pulse for driver’s priority door lock. IMPORTANT: You must isolate the driver’s door and
set feature 1-03 to option 2 (on).
Pin 4 Blue - Unlock 250mA, 800mS negative (-) output: This is an optional output that will provide a (-) pulse
for unlocking doors. System will unlock doors and disarm alarm. IMPORTANT: You must reverse
polarity for (+) trigger door lock systems. For additional lock settings review Option Group 1.
Pin 5 Blue/Black - Lock 250mA, 800mS (-) negative output: This is an optional output that will provide a (-)
pulse for locking doors. System will lock doors and arm alarm. IMPORTANT: You must reverse
polarity for (+) trigger door lock systems. For additional lock settings review Option Group 1. Pin 6 not
used.
Pin 6 None - B- ground output: available when using a Firstech door lock Module FT-DM600, FT-DM700
Connector 11 (CN11), 2-Pin (Pre-wired LED) **WHITE connector Note: Do not mistake for Thermistor
port. Note: The LED will stay solid blue when armed for the duration of the sensor set up time. (Approx.
25 seconds)
Pin 1 Black - L.E.D negative (-) ground.
Pin 2 Black/White- L.E.D. 2.5V positive (+) output.
Connector 12 (CN12), 4-Pin (Pre-wired RPS Touch or RPS 2)
Pin 1 Black - Negative (-) ground.
Pin 2 White - Negative (-) paging input.
Pin 3 Red - 12V positive (+)output.
Pin 4 Yellow - 9V positive (+) L.E.D. output.