Firstech CM-X - Page 29

CMX is t
he
Solution
https:// install.myfirstech.com
CMX
Master
Guide
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
29
Connector 13 (CN13), 4-Pin (Pre-wired DAS Sensor)
Pin 1 Black - Negative (-) ground when armed (GWA).
Pin 2 White - 2nd stage negative (-) input. (Instant trigger)
Pin 3 Red - 12V positive (+) output.
Pin 4 Yellow - 1st stage negative (-) input. (Warn away)
Connector 14 (CN14), 4-Pin (Optional Sensor Input) (4 PIN Green port)
This connector provides optional sensor inputs. Most commonly used with additional impact,
proximity, and tilt sensors.
Pin 1 Black – Negative (-) ground when armed.
Pin 2 Black/White [PIC 7] – AUX input (INSTANT TRIGGER): This wire default setting will trigger to full
alarm, if ground (-) is applied momentarily. This wire can be programmed to offer other input
functions based on the PIC setting value in special options group 3, using the OP500
Pin 3 Red – 12V positive (+) output.
Pin 4 Grey/White [PIC 6]– AUX Input (PREWARN): This wire default setting will trigger prewarning
chirps/horn honks if ground (-) is applied momentarily. This wire can be programmed to offer other
input functions based on the PIC setting value in special options group 3, using the OP500
Connector 15 (CN15), 2-Pin Siren output BROWN connector: This connector will provide a 600mA output
on the brown wire, and ground on the black wire. This will allow for additional sirens to be added to the CMX.
Pin 1 Black – Siren negative (-) ground.
Pin 2 Brown – Siren 600mA positive (+) output.