https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
47
3-02 Confirmation chirps: This feature will allow the user to select a shorter siren or horn output time to
simulate a quieter arm/disarm/start output.
FO1 - 30mS: This is a 30 millisecond siren output with arm, disarm, and start confirmation chirps. It
will produce a “medium” volume sound. (Softer than the standard 60mS output)
FO2 - 15mS: This is a 15-millisecond siren output with arm, disarm, and start confirmation chirps. It will
produce a “short” or quiet volume of sound. (Significantly softer than the standard 60mS output)
FO3 - 60mS: This is a standard 60 millisecond siren output with arm, disarm, and start confirmation
chirps.
3-03 Dome Light Delay: This option is used when connecting the door trigger input to the vehicles dome
light circuit. It delays the door trigger input to prevent the door open icon displaying on 2 Way
remotes upon lock/arm.
FO1- Off: (default)
FO2 - 5 seconds: This option will delay the door trigger input for 5 seconds when arming the
system to account for any vehicle dome light output delay.
FO3 - 45 seconds: This option will delay the door trigger input for 45 seconds when arming the
system to account for any vehicle dome light output delay.
FO4 - Auto: This option will allow the CMX to wait for a change in polarity on the door input circuit,
after the system has been armed, to monitor for security.
3-04 Starter-Kill: This option determines the operation of the GWA wire (POC 1 CN4 Pin 1 Blue/white)
FO1 - Anti grind + Starter interrupt: this option will allow for the Starter Kill wire to provide a
negative output when the system is armed or remote started. This will enable a starter interrupt to
prevent the vehicle from being started with the key when in an armed state or grinding the starter
during a secure remote start take over.
FO2 - Anti Grind only: This option will allow the Starter Kill wire to provide a negative output when the
system is remote started which can be used to enable starter interrupt and prevent the user from grinding
the starter during secure remote start take over.
FO3 - Anti Grind and passive starter interrupt: This option will allow for Starter Kill wire to provide a
negative output when the system is remote started, or the passive starter interrupt is engaged. This will
prevent the user from grinding the starter during secure remote start take over, and enable starter interrupt
45 seconds after the ignition has been turned off.
3-05 Anti-Jacking: Note: this feature requires the starter-kill relay to be wired to the ignition vs. the starter
wire. This feature will allow the CMX to interrupt the ignition wire if panic mode is activated while the
vehicle is running with the key.
FO1 - Off: (default) anti-carjacking feature is not enabled, and the starter interrupt will operate based on
feature 3-04 option setting.
To Next Page
Loading...