https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
52
-IF the user needs to disable the N/O secure start output for some reason, you can put the CMX into
Vale Mode. While in Valet mode the Secure Start Output will activate any time a door is opened,
(or when disarmed/unlocked) allowing the PTS button to function normally.
-The (-)NEG Valet Mode Input will need to be enabled to enter/exit Valet mode when using the
N/O Secure Start function. The open PTS button will not allow the vehicle to go to ignition on
position.
-NOTE: WE strongly recommend disabling the “OEM control of aftermarket security” function
when using an Idatalink interface with CMX. This will significantly increase the security of the
vehicle.
FO1 – OFF
FO2 – 2 min: once the system is disarmed/unlocked the PTS button will be fully functional for 2
minutes. IF the timer runs out the user must disarm/unlock again.
FO3 – 4 min: once the system is disarmed/unlocked the PTS button will be fully functional for 4
minutes. IF the timer runs out the user must disarm/unlock again.
FO4 – 10 min (PROG 1-10 min): once the system is disarmed/unlocked the PTS button will be fully
functional for 10 minutes. IF the timer runs out the user must disarm/unlock again. When set to
option 4 you may use an OP500 updated with OP500 v .36 (available for download at
Firstechdata.com) to change the timer between 1 and 10 minutes using 1-minute increments.
3-18 Normally Closed (N/C) Secure Start output Timer: The N/C Secure Start feature will provide an
output from any POC set to Secure Start N/C [33]. This output will send (-) 250mA for the period of
time selected by one of the options below.
It is designed to be used with our FTI-SPTS (secure Push To Start) vehicle disable T harnesses. In its
active state the N/C option used with the vehicle disable harness will disable the PTS button ONLY
WHEN THE ALARM IS TRIGGERED, all other times there will be no output from the N/C POC,
and the PTS button will function normally.
-During an alarm event the N/C will disable the PTS button for the selected time to make sure any
additional attempts to “hack” or force start the vehicle will not work even after the siren output times
out. Once the CMX is unlocked/disarmed the N/C output will no longer function making the PTS button
operate normally.
-NOT RECOMMEDED WHEN USING N/O SECURE START FEATURE.
-IF the user needs to disable the N/C Secure Start Output completely they will need to enter valet mode.
FO1 – OFF
FO2 – 1 min: This will activate the N/C Secure Start output, disabling the PTS button the exact time of
an alarm event and continue to provide output for up to 1 minute or until system is disarmed.
FO3 – 2 min: This will activate the N/C Secure Start output, disabling the PTS button the exact time of
an alarm event and continue to provide output for up to 2 minutes or until system is disarmed.
FO4 – 4 min: This will activate the N/C Secure Start output, disabling the PTS button at the exact time
of an alarm event and continue to provide output for up to 4 minutes or until system is disarmed.
4-01 Aux 1 Output: This feature determines the duration of the auxiliary 1 output. (Option 4 allows the
output duration to be set for a specific length of time 1-99 sec. and 1-15 min (with OP500 update only)
(Specific time setting only available when using the OP500)
To Next Page
Loading...