To Next Page

To Previous Page

2-14 PIC 1 (-): Programmable Input Channel provides 4 options for negative input to the CM7.

FO1 - (-) negative E-brake (aka: parking brake) input: This option allows the CM7 to read

input as e-brake which is needed to enter reservation mode or turbo timer mode. (Note: required for

manual transmission or turbo timer mode).

FO2 - (-) negative parking light reminder input: This option allow the CM7 to read input as

parking light reminder. If this input has ground, as soon as the system is locked/armed it will send a

notification to a 2 way LCD or Drone indicating parking lights are still on.

FO3 - (-) Trigger start input: This option will enable PIC1 to be used as a trigger for activating

the remote start function using a number of (-) pulses based off of feature 2-04 using the lt. Blue wire

CN5.

3-01 Parking Lights while Remote Started: This feature changes the parking light behavior during remote

start.

FO1 - Constant output: This option will keep the parking light output (+ and -) on steady

throughout the entire runtime (runtime based on feature 2-07 selection)

FO2 - Flashing output: This option will flash the parking light output (+ and -) throughout the

entire runtime (runtime based on feature 2-07 selection)

FO3 - Off: This option turns the parking lights off while the vehicle is remote started.

FO4 - Off with lock and unlock only: This feature is designed to eliminate redundant parking

light flash with lock/unlock when interface module flashes the parking lights controlling the Factory

security.

3-02 Confirmation chirps: This feature will allow the user to select a shorter siren output time to simulate a

quieter arm/disarm/start output.

FO1 - 30mS: This is a 30 milliseconds siren output with arm, disarm, and start confirmation chirps.

It will produce a “medium” volume sound. (Softer than the standard 60mS output)

FO2 - 15mS: This is a 15 millisecond siren output with arm, disarm, and start confirmation chirps. It

will produce a “short” or quiet volume of sound. (Significantly softer than the standard 60mS output)

FO3 - 60mS: This is a standard 60 millisecond siren output with arm, disarm, and start confirmation

chirps.

CM7200 Master Guide

Starter System

techfeed.compustar.com

Firstech CM7200 User Manual

Questions and Answers: