2-16 Force Remote Start shutdown: This feature will allow the user to have the remote start automatically
shut down as soon as there is a door zone opened.
FO1 – OFF (default)
FO2 – DOOR OPEN: This option will shut down the remote start0 when door zone is opened.
3-01 Parking Lights while Remote Started: This feature changes the parking light behavior during remote start.
FO1 - Constant output: This option will keep the parking light output (+ and -) on steady
throughout the entire runtime (runtime based on feature 2-07 selection)
FO2 - Flashing output: This option will flash the parking light output (+ and -) throughout the entire
runtime (runtime based on feature 2-07 selection)
FO3 - Off: This option turns the parking lights off while the vehicle is remote started.
FO4 - Off with lock and unlock only: This feature is designed to eliminate redundant parking light
flash with lock/unlock when interface module flashes the parking lights controlling the Factory
security. This will provide parking light output with remote start and troubleshooting diagnostics.
3-02 Confirmation chirps: This feature will allow the user to select a shorter siren or horn output time to
simulate a quieter arm/disarm/start output.
FO1 - 30mS: This is a 30 milliseconds siren output with arm, disarm, and start confirmation chirps. It
will produce a “medium” volume sound. (Softer than the standard 60mS output)
FO2 - 15mS: This is a 15-millisecond siren output with arm, disarm, and start confirmation chirps. It will
produce a “short” or quiet volume of sound. (Significantly softer than the standard 60mS output)
FO3 - 60mS: This is a standard 60 millisecond siren output with arm, disarm, and start confirmation
chirps.
3-03 Dome Light Delay: CM900AS ONLY This option is used when connecting the door trigger input to
the vehicles dome light circuit. It delays the door trigger input to prevent the door open icon displaying
on 2 Way remotes upon lock/arm.
FO1- Off: (default)
FO2 - 5 seconds: This option will delay the door trigger input for 5 seconds when arming the
system to account for any vehicle dome light output delay.
FO3 - 45 seconds: This option will delay the door trigger input for 45 seconds when arming the
system to account for any vehicle dome light output delay.
FO4 - Auto: This option will allow the CM900AS to wait for a change in polarity on the door input
circuit, after the system has been armed, to monitor for security.
3-04 Starter-Kill: This option determines the operation of the GWA wire (CM900AS CN3 Pin 18 Blue/white
– CM900S must use a POC set to Starter kill option 29)
FO1 - Anti grind + Starter interrupt: this option will allow for the Starter Kill wire to provide a
negative output when the system is armed or remote started. This will enable a starter interrupt to
prevent the vehicle from being started with the key when in an armed state or grinding the starter
during a secure remote start take over.
To Next Page
Loading...
Need help?
General
