To Next PageTo Next Page
Need help?Do you have a question about the Firstline FCS12000CH and is the answer not in the manual?
General| Type | Split System |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Noise Level (Outdoor) | 52 dB |
| Cooling Capacity | 12000 BTU/h |
Ensure proper grounding connection to earth for electrical safety and avoid connecting cables in the middle.
Avoid pulling power cables, damaging wires, or using faulty plugs to prevent fire or electric shock.
Avoid direct cool air blowing for extended periods to prevent potential health problems.
Do not use multi-hole sockets or connect cables in the middle to prevent fire or shock hazards.
Unplug the unit or cut power supply when not in use to prevent hazards from accumulated dirt.
Use a soft dry cloth for cleaning; avoid chemical solvents or flammable sprays.
Install according to regulations, 2.3m above floor, and not in laundry areas.
Keep away from flammable gas storage and burning appliances to prevent ignition.
Close windows/doors during operation; limit usage in high humidity to prevent issues.
Stop operation immediately if a burning smell is detected from the unit.
Identifies key components of the indoor unit, including filters, panels, and deflectors.
Identifies key components of the outdoor unit, including inlets, outlets, pipes, and hoses.
Details the operation display and primary control buttons like Run/Stop and Temp Adjustment.
Identifies buttons for mode selection, fan speed adjustment, and timer/sleep functions.
Instructions for inserting batteries and setting the correct time on the remote control.
Guidance on remote operation distance, handling, and battery removal when not in use.
How to start/stop operation, adjust temperature, and vary fan speed using the remote.
Setting the sleep operation for comfortable room temperature maintenance overnight.
Manual and automatic control of air flow direction using deflector adjustments.
Recommended deflector AUTO mode settings for Dry/Cool and Heat modes.
Control deflector movement via remote and avoid manual adjustments to prevent injury.
Explanation of Auto, Cool, and Dry modes and their respective control adjustments.
Using Fan mode for air recycling and Heat mode with temperature adjustments.
Procedure for setting desired start and stop times for the air conditioner operation.
Understanding time function display and how to cancel timer settings.
Instructions for drying the unit before storage and powering down.
Steps to turn off, disconnect power, and remove batteries from the remote for storage.
Guide on how to take out, clean (vacuum or wash), and dry air filters.
Procedure for inserting the cleaned filters back into their original positions.
Common issues like unit not operating, delayed start, or poor efficiency, with possible causes.
Diagnosing issues with the remote control not working or displaying correctly.
Explanation for delayed airflow at the start of Heat mode due to processing.
Explains that fan stops are normal during defrosting of the outdoor unit coil.
Describes causes for cracking sounds (expansion/contraction) and running water sounds (refrigerant).
Explains 'poosh' sounds (fan/compressor) and water leakage (normal cycle).
