Panda xControl
Page 22 - Chapter 2: Panda xControl 29.9.16
the factory settings
7. Back
- Switching from the "Generator" sub-menu to the Main
Menu
2.5.3.1 Setting the Autostart of the CP-G
The menu item is selected by using the "Step-up"/"Step-down" keys confirmed with the "Start/Stop - Enter“ key. The
respective menu item opens.
Fig. 2.5.3.1-1: AutostartA choice can be made between "Switch on/off" and "Number
of start-up attempts" in in the "Autostart" sub-menu.
Fig. 2.5.3.1-2: AutostartSwitching On / Off
"Off" for deactivated or "On" for activated can be selected by
using the "Step-up"/"Step-down" keys and then confirmed
with the "Start/Stop - Enter“ key.
"Cancel" or "Confirm" can be selected by using the "Step-up"/
"Step-down" keys and then confirmed with the "Start/Stop -
Enter“ key.
Fig. 2.5.3.1-3: AutostartNumber of start-up attempts
The value is changed by using the "Step-up"/"Step-down"
keys and the setting is confirmed with the "Start/Stop - Enter“
key.
"Cancel" or "Confirm" can be selected by using the "Step-up"/
"Step-down" keys and then confirmed with the "Start/Stop -
Enter“ key.
For safety reasons, the number of start-up attempts is limited
to one in the case of marine (PMS) generators.
Warning! Automatic start-upDeadly danger! - The generator can be equipped with an
Autostart function. This means that the generator is
started by an external signal. In order to prevent an
inadvertent start-up, the starter battery must be
disconnected before work on the generator may
commence.
The "Autostart" also remains active if the xControl CP-G
is switched off and then on again.
If a fault should arise when the generator is started or is already operating, it is stopped and the Autostart is set to
"off".
If the generator is operated by Autostart and is stopped manually, the Autostart is set to "off".
Once the system has been switched off and then on again, the Autostart is active once more.
To Next Page
Loading...
Need help?
General
