23
Bl u e t o o t h Co n t r o l Se t op e r at i n g m a n u a l
10 Smartphone App Bluetooth Control
With the Smartphone App Bluetooth Control (for Version 5.0 Android and higher and iOS), one
or two receivers can be controlled using the Smartphone. This App can completely replace the
transmitter and offers the same scope of functions. The App is available for free in the respective
Playstore/App Store.
11 Technical Data
Control Set for control of 3 motors and 1 servo
Frequency band Bluetooth
Max. emitted transmission power
2,402 – 2,480 GHz
1,37 mW
Range 10 m
Transmitter power supply 9 V block battery
Number of possible receivers per transmitter 2
Number of possible pairs (each transmitter + receiver) in one room
without interfering with each other
as many as desired
Receiver power supply 9 V
Accu Set
Receiver output power load per output, max. 0,8 A
12 If it does not function...
The LEDs of the transmitter and receiver emit various flash codes, which signal the respective
operating state.
LED on transmitter Description
LED lit continuously Battery voltage OK The transmitter is paired with the receiver
LED flashes 1x per sec. Transmitter is not paired with any receiver
LED flashes approx. 2x per sec.
The battery is almost empty and must be replaced. The full range is
no longer guaranteed
LED does not light after
switching on
The battery is empty, battery not correctly plugged in. Transmitter is
faulty (contact fischertechnik Service)
To Next Page
Loading...