34
6.2.8 Special Option Mode (Israel)
The Active Smart refrigerator is fitted with a special option mode, should the customer wish to disconnect the
operation of the interior lights and the alarm.
To enter this mode the customer is required to push and hold the compartment select MODE button on the
display board for 10 seconds.
When the cabinet is in this special option mode the following will not operate:
The interior light will not turn on when the PC door is opened.
There will be no set temperature lights (L.E.D.s) displayed on the display module.
The door alarm will be disconnected and will not sound even if the doors were to be left open.
The customer may exit this mode at anytime by pushing and holding the compartment select MODE button
for 10 seconds.
Note: When in the special option mode the Active Smart will operate as normal without the above being
used. In normal operation, the set temperature L.E.D.s and interior light will be seen when the PC door is
opened.
6.3 Door Gasket - (Integral)
The door gasket is able to be replaced as a separate part.
All replacement doors are supplied minus the door gasket. The door gasket is a replaceable part of the
door. It is held in place against the door liner by means of a moulding which locks the gasket in place once
pushed into it. There are no screws or retainers to remove or fit.
To Remove the Gasket
Pull on any section of the gasket to pull it away from the moulding.
To Replace the Gasket
Having removed the old gasket, lay the new gasket around the door gasket moulding. First fit all corners,
then push the remaining gasket into place around the door.
Diagram 6.3