So_ving operating problems
at the wa!!! ...............................................................................................................................................................................................................................................................................
u g!!omwa!!:Wa tor,d !u c n an@ a_a_n:...................................
Could househoM power supply be at fauk7 Try phgging in another appliance.
N sN@N@J@N t:i .............
Are the inlet hose filters blocked? Check the ends of the hoses.
Ensure drain hose is located in standpipe or set tub/sink_
Ensure standpipe or set tub/sink is at least S3 Y2"(850 ram) high and no more than
96" (2438 ram) high,
Check that the washer is not siphoning (refer to page 9),
Ensure load is not out of balance.
Check washer is levd and does not rocL
Ensure washer does not have suds buildup
Check that the washer is not siphoning (refer to page 9).
Clothes are unevenly distributed in wash tub, your washer has slowed the spin to compensate,
",/our washer is designed to automatically sense load size and minimize water use, therefore the
water level may look different to your previous washer, this is normal,
This unique wash system uses two wash phases, The second phase can be cooler than the first to
minimize energy use. This is normal and will not affect wash performance.
Ensure that you are using a High Efficiency (HE) detergent
Try using a little less detergent, especially if garments are only lightly soiled,
To Next Page
Loading...
