nsta ation instructions
Before you begin - read these instructions comp[ete[y and carefu[[yo
Electric Shock Hazard
Read and follow the IMPORTANT SAFETY iNSTRUCTIONS outlined in this
UserGuide before operating this appliance, pages 3 .- 5o
Improper connection of an equipment-grounding conductor can result in a
risk of electric shock° Check with a qualified e_ectrician or serviceman if you
are in doubt as to whether the appliance is propedy grounded°
Do not modi_ the plug provided with the appliance .-if it will not fit the
out_et, have a proper out_et installed by a qualified e_ectdciano
Failure to do so can result in death, e_ectric shock, fire or injury to persons°
Observe aft governing codes and ordinances.
h_stallation Requirements
Location
Your washer must be installed on firm flooring to minimize vibration during spin cycles, Concrete
flooring isbest, but a wood base issufficient providing the floor support meets FHAstandards,
Your washer should not be installed on rugs or exposed to the weather,
Water Temperature
",,!ourcold water should not exceed 95°F (35°C) or your hot water exceed 149°F (65°C).
Temperatures above this may damage your washer.
Shut Off Valves
Both hot and cold shuboff valves (faucets) should be available in the laundry area.
Drain
Water may be drained into a standpipe or set tub/s[nL The standpipe must be 1 Y2"(38 ram)
minimum intedor diameter and must be open to the atmosphere.
E[ectdca[
This appliance must be supplied with 110V- 120V, 60Hz electrical supply and connected to an
individual, properly grounded branch circuit, protected by a 15 or 20 amp circuit breaker or time
delay fuse.
To Next Page
Loading...
