16
PLUMBING & ELECTRICAL CONNECTION
Connect the inlet hose to tap and hand-
tighten into place.
Using a spanner or pliers, turn a further
180° to secure. Avoiding over-tightening.
Do not turn water supply on. The
DishDrawer™ Dishwasher must be
powered on for the flood protection
feature to be enabled.
Install your Air Gap Kit to the benchtop.
We recommend using a Dual Air Gap Kit.
Refer to ‘Plumbing & electrical
connection’ for minimum install heights.
Plug product in.
AIR GAP INSTALLATION
1
2
3
4
Thread wire clips onto the hoses before
fitting them to the hose joiner. Secure
using the wire clips. Fit the joiner to the
Air Gap Kit and secure using the hose
clamp. Ensure hoses are routed straight
to the joiner, removing excess drain hose
if necessary.
Unplug or drill out the waste tee before
securing to sink trap or waste tee.
Dual Air Gap Single Air Gap
To Next Page
Loading...
