34
USER MAINTENANCE INSTRUCTIONS
IMPORTANT!
Disconnect the dishwasher from the power supply (unplug or switch off at the circuit
breaker) and allow all its parts to cool before any cleaning or maintenance.
Holiday time
●
If the dishwasher is not going to be used for some time, we recommend you leave
it clean and empty. Leave the drawers ajar to allow air to circulate. Turn off both the
power and water supply to the dishwasher.
When using your dishwasher for the first time after a long period away, we recommend
pouring 3 cups of water into the drawer before loading and starting a wash. This is to
lubricate components that may have dried out during non-use.
●
If the dishwasher is installed in a cold climate where temperatures fall below zero, we
also recommend winterizing.
Winterizing (Cold climates only)
1 Disconnect the dishwasher from the power supply,
2 Turn off the water supply and disconnect the water inlet pipe from the water valve.
3 Drain water from the inlet pipe and water valve, using a bucket or pan to collect the
water.
4 Reconnnect the water inlet pipe to the water valve.
5 Remove the drain filter and the filter plate from the bottom of the drawer and use a
sponge to remove any remaining water underneath.
6 Replace the drain filter and the filter plate, and completely dry all water from inside the
dishwasher.
7 Disconnect the drain hose(s) from the sink drain pipe and completely drain all remaining
water from the hose(s). Reconnect the drain hose(s) to the sink drain pipe.
To Next Page
Loading...
Need help?
General
