19
Loading the dishwasher
Using the adjustable cup racks on the lower basket
Use these racks for cups, glasses, long-handled cutlery and other utensils (see Fig.12).
If you don’t need them, you can easily fold them away. See the instructions below.
These racks are mounted on a wire support which clips onto the rear side of the lower basket.
If you decide not to use the cup racks at all, you may remove the entire wire support. See ‘To
remove and replace the cup racks’ below.
To remove and replace the cup racks
1
Disengage the gripping wires at the feet of the wire support (see Fig. 12).
2
Pull the wire support up and away from the basket.
3
Reverse to replace, making sure that the gripping wires and basket interlock and the wire
support clicks tightly into place.
To fold away a cup rack (Fig. 13)
1
Tilt the rack upwards at the angle shown.
2
Slide the rack all the way up the wires.
3
Tilt the rack further up until it is completely vertical.
4
Push the rack all the way down and lock it into place with the small gripping hooks.
When you want to use the rack again, repeat the above steps in reverse order.
1019
Fig. 12 Using the adjustable cup racks
Gripping
wires
Wire support
To Next Page
Loading...
Need help?
General
