20
Loading the dishwasher
To adjust the height of a cup rack (Fig. 14)
To adjust the height of a cup rack, follow steps 1 to 3 above, then lower the rack back into a
horizontal position, making sure that you keep it at the uppermost point of the wire support. The
two plastic tabs on the back of the cup rack will sit on a support wire, keeping the rack securely
in place.
After adjusting the height, check that the spray arm can still move freely.
Using the bottle support
Use this to give tall bottles extra stability during a wash programme. To remove, press the
gripping wire feet apart so that they unhook from the basket wires, as shown in Fig.15.
1020
Fig. 13 Folding away a cup rack
Fig. 14 Adjusting the height of a cup rack
Fig. 15 Removing the bottle support
1
2
3
4
4
1
2
3
Gripping hooks
Plastic tabs
To Next Page
Loading...
Need help?
General
