Need help?Do you have a question about the Fisher & Paykel GC600WFC and is the answer not in the manual?
General| Brand | Fisher & Paykel |
|---|---|
| Model | GC600WFC |
| Category | Cooktop |
| Language | English |
Details physical dimensions for GC600, GC900, and GC9002/GC36 series.
Explains the meaning of model codes (e.g., GC, W, F, Q, JET).
Specifies required bench cut-out dimensions for installation of different cooktop series.
Lists burner types, orifice sizes, and gas ratings for Australia/NZ, GB/IE, and USA/Canada.
Lists part numbers for standard and flame failure gas valves used in controls.
Details mains powered ignition system specifications for 600, 900, and GC36 series.
Provides total gas ratings (MJ/h, kW, BTU) for various models and gas types.
States gas products must only be installed and serviced by qualified gas service persons.
Illustrates the ignition circuit for GC600, GC900, and GC9002 series gas cooktops.
Shows the ignition circuit for the GC36 gas cooktops in USA & Canada.
Instructions for checking and adjusting the minimum flame setting (turn down) on burners.
Provides steps for converting the cooktop to operate with different gas types (NG/LPG).
Step-by-step guide for safely removing the hob top assembly from the cooktop.
Instructions for disconnecting and removing the entire cooktop from its bench or countertop installation.
Procedure for replacing a faulty ignition electrode on the cooktop.
Steps involved in replacing the electronic ignition control box.
Guide for replacing the microswitch wiring loom on GC600, GC600W, and GC36 models.
Method for testing the functionality of the flame failure safety system.
Instructions for replacing the thermocouple, a key component of flame safety.
Detailed procedure for removing and replacing a gas valve on the cooktop.
Steps for lubricating and maintaining gas valves for optimal performance.
Troubleshooting steps for ignition failures when no spark is detected.
Troubleshooting steps for ignition failures when spark is present but gas does not ignite.
Troubleshooting steps when the flame extinguishes after releasing the control knob.
Troubleshooting no spark issues in auto-reignition systems.
Troubleshooting ignition issues with spark but no ignition in auto-reignition systems.
Diagnosing continuous sparking after burner ignition in auto-reignition systems.
Troubleshooting flame extinguishing on the low setting in auto-reignition systems.
Diagnosing distorted, large, or yellow flames in auto-reignition systems.
To Next Page