Need help?Do you have a question about the Fisher & Paykel GC901 and is the answer not in the manual?
General| Number of Burners | 5 |
|---|---|
| Material | Stainless Steel |
| Safety Features | Flame failure protection |
| Type | Gas |
| Width | 900 mm |
| Burner Types | Wok Burner, Dual Ring Burner, Auxiliary Burner |
| Ignition Type | Electronic |
Detailed physical measurements of the cooktop for installation.
Clarifies differences between GC901 and GC901QT models and markets.
Specifies required dimensions for integrating the cooktop into countertops.
Safety clearances required for installation in the USA market.
Refers to installation instructions for clearances in markets other than USA.
Details burner types, gas ratings (BTU/kW), and orifice sizes for different gas types.
Lists the types and part numbers of valves and control components used.
Specifies electrical requirements and part numbers for ignition systems.
Crucial safety warning about qualified personnel for installation and servicing.
Schematic illustrating the ignition system wiring for GC901QT models.
Schematic illustrating the ignition system wiring for GC901 models.
Procedure for adjusting the minimum gas flame setting on burners.
Steps for changing gas type by replacing burner orifices and adjusting regulators.
Step-by-step guide for safely removing the cooktop's top panel.
Instructions for detaching the entire cooktop unit from its installed location.
Procedure for replacing faulty ignition electrodes on the burners.
Steps for replacing the main electronic ignition control unit.
Instructions for replacing the microswitch wiring harness specific to GC901 models.
Detailed procedure for replacing individual gas control valves.
Steps for lubricating gas valves to ensure smooth operation and prevent leaks.
Troubleshooting steps for ignition failures where no spark is generated.
Troubleshooting steps when a spark is present but the gas does not ignite.
Diagnosing and resolving issues where the ignition system sparks constantly.
Troubleshooting causes for the flame extinguishing at the lowest burner setting.
Diagnosing and correcting issues related to abnormal flame appearance.
To Next Page
