Fisher & Paykel GC901 - Flame Goes Out on Low Setting; Flame is Distorted or Large and Yellow

3. If the problem occurs with either the front left or right rear rapid burners. Replace with new
burner spreader (Part No. 531605).
4. If the problem occurs with the central 'triple ring' burner. Check that the ceramic body has
not been damaged. Replace with a new electrode (Part No. 531603).
5. Check each burner lights and doesn't continue sparking.
8.4 Flame Goes Out on Low Setting
Check the cooktop and regulator are set up for the correct gas type and pressure (factory set for
NG).
Check the burners low setting is correct (see Section 3.1).
8.5 Flame is Distorted or Large and Yellow
Check the cooktop and Regulator are set up for the correct gas type and pressure (factory set for
NG).
Check the burner components including the burner cap are sitting correctly.
14