Fisher & Paykel GC901 - Specifications; Product Dimensions; Model Explanation; Bench;Counter-Top Cut-Out Dimensions

3
1.0 SPECIFICATIONS
1.1 Product Dimensions
GC901/GC901QT
Length 36" (914mm)
Width 21
1
/
2
" (546mm)
Depth below bench/counter-top 2
9
/
16
" (65mm)
1.2 Model Explanation
GC901 model is made for the US/Canadian market with Auto reignition.
GC901QT model is made for the NZ/Australian and GB/IE market with Flame Failure and is known
as Titan Gas Cooktop. (Q= Quantum, T= Titan).
1.3 Bench/Counter-Top Cut-Out Dimensions for GC901/GC901QT
Min Max
Length 33
7
/
8
" (858mm) 35
1
/
4
" (894mm)
Width 19
1
/
8
" (485mm) 20
5
/
8
" (526mm)
Depth for clearance 2
9
/
16
" (product) +
3
/
4
" (ventilation) = 3
5
/
8
" below bench
1.4 Clearances for USA
§ Minimum horizontal distances from side and back of cutout to adjacent vertical combustible
walls (extending a minimum of 18" (457mm) from above the top panel) must be 1
1
/
4
" (32mm)
from the left side wall, 1"(25mm) from the right side wall and 1
1
/
4
" (32mm) from the rear wall.
§ Minimum horizontal distance from front edge of counter to front side of cutout 1
1
/
4
" (32mm).
Where this reduces the distance between the back edge of the cutout and the adjacent wall to
less than 1
1
/
4
", this wall must be of a non combustible material.
§ Minimum clearance to combustible surface centred above cooking surface 30" (762mm).
§ Minimum horizontal distance between overhead cabinets installed on either side of this
appliance 36" (914mm).
§ Maximum depth of overhead cupboards, 13" (330mm).
§ These distances shall be from the outermost edge of the top panel.
1.5 Clearances for Other Markets
§ See Installation Instructions supplied with the product.