1. Drill four 8 mm diameter holes for the fixing screws (two in the wall and two in the floor - see Fig.3) and insert
the plastic plugs supplied.
Before drilling the holes, check that you will not damage any pipes or electrical wires.
2. Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as shown in Fig. 3.
3. After attaching the anti-tilt bracket securely, slide the cooker into place. Ensure that the left rear foot slides
under the bracket, as shown in Fig.3.
4. Replace the kickstrip using the two screws.
• When sliding the cooker into place be careful not to trap the power supply cable in the anti-tip
bracket. Pay extra attention to the gas connection hose.
• Beware of sharp edges when removing or replacing the drawer.
Fig. 3 Attaching the anti-tilt bracket and sliding the cooker into place
https://producthelp.fisherpaykel.com/eu/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX3/User_Guide_OR90SDBGFX…
Updated: Thu, 26 Mar 2020 03:34:19 GMT
Powered by
4
To Next Page
Loading...
