17
Selecting a program and operating your machine
Changing the selections after the program has started
Turning the program knob while the program is in a normal flow will not change the program.
The program needs to be paused or cancelled before changes can be made.
Door lock
The loading door can not be opened whilst the “Ready” lamp is flashing due to safety reasons.
Once the “Ready” lamp lights continuously the door is able to be opened.
Adding additional laundry
Press the “Start/Pause” button to pause the program.
If the water level does not exceed the limitations, in 1 to 2 minutes the door lock will be
deactivated. Laundry may be added / taken out by opening the door.
If, after 2 minutes, the door is unable to be opened, it means that the water level inside the
machine is too high for the door to be opened and laundry added (refer to “Cancelling the
program”).
Pausing the program
Press “Start/Pause” button momentarily to switch your machine to the standby mode.
Additional functions can be cancelled or selected according to the stage of cycle the current
program is at.
Cancelling the program
If the program has started and you want to cancel it:
1 Press and hold the “Start/Pause” button for 3 seconds.
2 The program will move to the “spin” step.
3 The water will be drained, and after 1 –2 minutes the door can be opened.
Note:
The “Ready” warning lamp flashes during cancelling and “End” will appear on the display.
To Next Page
Loading...
