5
Installation instructions
Adjusting the feet
In order for quiet and stable operation, the machine should be placed properly and levelled on
its feet.
If the machine is unstable:
1 Loosen the plastic lock nut
2 Screw or unscrew the adjustable foot until the machine stands firmly level.
3 Tighten the lock nut for stability.
Note:
Do not use any tools to loosen or tighten the lock nuts, as they can be damaged.
Connecting to the water supply
Important:
Hot water should not exceed 65
º
C.
Cold water should not exceed 35
º
C
Temperatures above these may cause the machine to fault or result in damage to the machine.
If you have an uncontrolled water heating source (eg. Wet back or solar heating system) you
should fit a Safe Valve. This will ensure the hot water temperature remains within safe limits.
Water supply requirements
Inlet water pressure: Max. 1Mpa (150 psi) Min. 34Pa (5 psi)
Inlet water flow rate: Min. 3 litres/min
To Next Page
Loading...
Need help?
General
