21
Care and cleaning
To clean the filter and discharge the water:
1 Unplug the machine to cut off the supply power.
2 Open the service panel by holding both sides and pulling outwards.
3 Pull out the pump outlet hose from its housing.
4 Place a large container at the end of the hose.
5 Drain the water off into the container by pulling out the plug at the end of the hose.
If the amount of water to be drained off is greater than the volume of the container, replace the
plug, pour the water out, then resume the draining process.
After the draining process is completed:
6 Replace the plug into the end of the hose.
7 Refit the hose back into the housing.
8 Refit the service panel by fitting the tabs on the bottom into their positions and pushing the
upper part of the service panel back into place.
To Next Page
Loading...
